| Connectors | E1: (2) 75 ohm coax; (1) duplex or simplex fiber optic T1/E1: (1) UTP 100/120 ohm RJ-45; (1) duplex or simplex fiber optic |
| Fiber Optic Connector Specs |
| Multimode | Min TX PWR: -19.0 dBm
Max TX PWR: -14.0 dBm
RX Sensitivity: -32.5 dBm
Max In PWR: -14.0 dBm
Link Budget: 13.50 dB |
| Switches | SW1: 1,2,3: Line Build out for short haul/DB in Long Haul (See Table) Short Haul Mode:
SW1: Pos 4 not used SW2 - 1:Transmit all ones into copper on loss of fiber link (Up=Disabled) SW2 - 2:Transmit all ones (AIS) into fiber on loss of copper link (Up=Disabled) SW2 - 3: Long Haul/Short Haul (Up=Short Haul) SW2 - 4: T1/E1 selection (Up=T1) |
| 3-position Jumper | Hardware: Converter mode is determined by 4-position switch settings
Software: Converter mode is determined by most recently saved on-board microprocessor settings. |
| Status LEDs | PWR (Power): Steady green LED indicates connection to external AC power
SDC (Signal Detect/Copper): On indicates twisted pair link is up
SDF (Signal Detect/Fiber): On indicates fiber link is up |
| Dimensions | Width: 3.25" (82 mm)
Depth: 4.8" (122 mm)
Height: 1.0" (25 mm) |
| Power | External AC/DC required; 12V DC; .5A; unregulated; standard |
| Environment | 0 – 50°C operating;
5 – 95% humidity non-condensing;
0 – 10,000 feet altitude |
| Safety Compliance | Wall Mount Power Supply:
UL listed and CSA certified |
| Regulatory Compliance | FCC Class A, CISPR/EN55022 Class A, CE Mark |
| Switch Settings | | Long Haul (SW1-3 unused) | | SW1-1 | SW1-2 | | | Down | Down | 0 db output pulse | | Up | Down | -7.5 db output pulse | | Down | Up | -15 db output pulse | | Up | Up | -22.5 db output pulse |
| Short Haul (SW1-4 unused) | | SW1-1 | SW1-2 | SW1-3 | | | Up | Up | Down | DSX-1, 0-133 ft. | | Down | Down | Up | DSX-1, 133-266 ft. | | Up | Down | Up | DSX-1, 266-399 ft. | | Down | Up | Up | DSX-1, 399-533 ft. | | Up | Up | Up | DSX-1, 533-655 ft. | | Up | Up | Down | ANSI, T1.403 | | Down | Up | Down | DSX-1, 6.0 V |
|
