| Connectors | E1: (2) 75 ohm coax; (1) duplex or simplex fiber optic
T1/E1: (1) UTP 100/120 ohm RJ-45; (1) duplex or simplex fiber optic |
| Fiber Optic Connector Specs |
| Multimode | Min TX PWR: -19.0 dBm
Max TX PWR: -14.0 dBm
RX Sensitivity: -32.5 dBm
Max In PWR: -14.0 dBm
Link Budget: 13.50 dB |
| Switches | SW1: 1,2,3: Line Build out for short haul/DB in Long Haul (See Table)
Short Haul Mode:
Pos 4 not used
SW2 - 1:Transmit all ones into copper on loss of fiber link (Up=Disabled)
SW2 - 2:Transmit all ones (AIS) into fiber on loss of copper link (Up=Disabled)
SW2 - 3: Long Haul/Short Haul (Up=Short Haul)
SW2 - 4: T1/E1 selection (Up=T1) |
| 3-position Jumper | Hardware: Converter mode is determined by 4-position switch settings
Software: Converter mode is determined by most recently saved on-board microprocessor settings. |
| Status LEDs | PWR (Power): Steady green LED indicates connection to external AC power
SDC (Signal Detect/Copper): On indicates twisted pair link is up
SDF (Signal Detect/Fiber): On indicates fiber link is up |
| Dimensions | Width: 0.86" (22 mm)
Depth: 5.0" (127 mm)
Height: 3.4" (86 mm) |
| Environment | See chassis specifications |
| Compliance | UL Listed, C-UL Listed (Canada); CISPR/EN55022 Class A; FCC Class A; CE Mark |
| Switch Settings | | Long Haul (SW1-3 unused) | | SW1-1 | SW1-2 | | | Down | Down | 0 db output pulse | | Up | Down | -7.5 db output pulse | | Down | Up | -15 db output pulse | | Up | Up | -22.5 db output pulse |
| Short Haul (SW1-4 unused) | | SW1-1 | SW1-2 | SW1-3 | | | Up | Up | Down | DSX-1, 0-133 ft. | | Down | Down | Up | DSX-1, 133-266 ft. | | Up | Down | Up | DSX-1, 266-399 ft. | | Down | Up | Up | DSX-1, 399-533 ft. | | Up | Up | Up | DSX-1, 533-655 ft. | | Up | Up | Down | ANSI, T1.403 | | Down | Up | Down | DSX-1, 6.0 V |
|
