| Connectors | 1 RJ-45 (100 meters); 1 duplex or simplex fiber optic |
| Fiber Optic Connector Specs |
| Multimode | Min TX PWR: -19.0 dBm
Max TX PWR: -14.0 dBm
RX Sensitivity: -30.0 dBm
Max In PWR: -14.0 dBm
Link Budget: 11.00 dB |
| 3-position Jumper | Hardware
Converter mode is determined by 4-position switch settings
Software
Converter mode is determined by most recently saved on-board microprocessor settings |
| 4-position Switch | Pos 1
(UP) Advertises 100Mb/s full-duplex/half-duplex during auto-negotiation. (DOWN) (Used primarily when connecting to hub.) Operates at 100Mb/s in duplex mode of attached device.
Pos 2 Applies only if Switch 1 is UP AND media converter is connected to auto-negotiating device(s) capable of Pause Control Frame propagation.
(UP) ALLOWS negotiation of Pause Control Frame.
(DOWN) Does NOT allow negotiation of Pause Control Frame.
Pos 3
(UP) Enables Link Pass Through.
(DOWN) Disables Link Pass Through
Pos 4
(UP) Enables Far End Fault
(DOWN) Disables Far End Fault |
| Status LEDs | Power
Steady green LED indicates connection to external AC power.
LKF (Fiber Link)
Steady LED indicates fiber link connection.
RXF (Fiber Receive) Flashing LED indictes data reception on fiber link
RXC (Copper Receive) Flashing LED indicates data reception on copper link
LKC (Copper Link)
Steady LED indicates copper link connection. |
| Environment | see chassis specifications |
| Dimensions | Width: 0.86" (22mm)
Depth: 5.0" (127mm)
Height: 3.4"(86mm)
|
| Compliance | C-UL Listed (Canada) UL Listed; CISPR22/EN55022 Class A & B + EN55024; FCC Class A & B; CE Mark |
